FAQ

Frequently asked questions

Formula Keypressed command list
The Keypressed option in formula uses the virtual key codes. Here is the example for enter key on keyboard: Symbolic constant nameValue (decimal)Mouse...
Thu, 16 Jan, 2020 at 9:44 AM
Filename from dynamic input
Very often performing numerous measurements with different setups means a lot of data files which is difficult to group and classify. Changing store filenam...
Thu, 13 Feb, 2020 at 2:01 PM
EtherCAT devices LED blinking codes
Each Krypton slice has 3 green LEDs: L - D - L. The LED blinking codes adhere to the EtherCAT specification.  L means Link: i.e. the In- (left L-LED) or O...
Wed, 28 Feb, 2024 at 12:15 PM
LORD sensors which were tested with LORD Micro Strain plugin
3DM-GX5-25 SHM-Link V-Link-200 G-Link-200 SG-link-200-OEM 3DM-GX5-15
Wed, 12 Feb, 2020 at 4:05 PM
Difference between Master/View/Slave client in NET system
In this guide, we'll take a look at the differences between the Remote modes in the Dewesoft NET system.  1. Master client: Can control the measure...
Mon, 24 Feb, 2020 at 7:50 AM
Current output from DO pin on different devices
In this article is gathered all the data about maximum current output on the DO pin for different devices: Krypton 1xCNT: Output voltage +5V - curren...
Fri, 3 Dec, 2021 at 3:48 PM
The difference between direct shunt and loop powered shunt
When the DSI-20mA adaptor is connected to a device the amplifier will change its setup to current mode only, then it is hard to see what is going on in the...
Mon, 2 May, 2022 at 10:47 AM
How to use Multiple monitors
In DewesoftX you can use many monitors for displaying separate Measure screens. This is a simple how-to step-by-step article. HINT If you're lookin...
Sat, 22 May, 2021 at 9:10 PM
Windows Firewall - switching it On or Off
Working with the DS-NET option in DeweSoft you are required to establish an IP connection with a host acquisition device. There are many configurations of m...
Thu, 7 May, 2020 at 9:36 AM
Start measurement automatically with system boot
This document describes the steps to do, if you want a measurement to be started just after booting up the computer (without doing any keyboard/mouse opera...
Fri, 8 May, 2020 at 10:41 AM