FAQ

Frequently asked questions

SIRIUSe analog ouput via EtherCAT connection
Explained below are the different functionalities that can be used on SIRIUSe device. It is important to pay special attention to the function generator mod...
Tue, 10 Mar, 2020 at 1:44 PM
Synchronisation time source
You can adjust the synchronization time source for the system in the Device Settings. The clock provider can be a Dewesoft DAQ device (the device generates ...
Mon, 20 Jul, 2020 at 3:08 PM
Current output from DO pin on different devices
In this article is gathered all the data about maximum current output on the DO pin for different devices: Krypton 1xCNT: Output voltage +5V - curren...
Mon, 30 Mar, 2020 at 12:21 PM
The difference between direct shunt and loop powered shunt
When the DS-20mA adaptor is connected the amplifier will change its setup to current mode only, then it is hard to see what is going on in the background. ...
Mon, 30 Mar, 2020 at 12:21 PM
How to use Multiple monitors
In Dewesoft X3 you can use many monitors for displaying separate Measure screen. This is a simple how-to step-by-step. 1. Make sure that all displays ar...
Wed, 6 May, 2020 at 12:48 PM
Windows Firewall - switching it On or Off
Working with the DS-NET option in DeweSoft you are required to establish an IP connection with a host acquisition device. There are many configurations of m...
Thu, 7 May, 2020 at 9:36 AM
Start measurement automatically with system boot
This document describes the steps to do, if you want a measurement to be started just after booting up the computer (without doing any keyboard/mouse opera...
Fri, 8 May, 2020 at 10:41 AM
How to run Multiple instances in multiple User logins in Windows
The following article shows how to run multiple instances in multiple User logins in Windows. Take into account that this option is recommended strictly for...
Mon, 10 Aug, 2020 at 9:03 AM
How to provide NTP synchronisation from master client to measurement units in local network
Instructions for the following Windows operating systems: Windows 7 (32-bit and 64-bit) Windows 10 (32-bit and 64-bit) Windows Server 2008 R2 (64-bit) ...
Mon, 13 Jul, 2020 at 8:24 AM
Multifile opening with Sequencer
This article gives basic information about how to open Multifile with Sequencer.  Use the Action block and find the "LoadFile" in the DCOM str...
Wed, 22 Jul, 2020 at 11:42 AM