Hardware

Hardware-related topics

DEWE-43A sensor power supply short-circuit
In case of an over-current condition the output current will be limited to 430mA max for 10msec. If the over-current condition persists the supply will turn...
Fri, 21 Dec, 2018 at 12:42 PM
Overload on modules without sensor
The phenomenon where measuring signal goes in overload is cause by the high impedance of an amplifier. Whenever the input impedance is higher than for exampl...
Mon, 21 Jan, 2019 at 3:38 PM
Slew rate on Dewesoft USB devices
Standard Amplifiers with DeltaSigma ADC & 100kHz LPF We have measured the Slew rate / rise time on DEWE-43, STGM v3, ACC and HD amplifiers: Settin...
Fri, 3 Jul, 2020 at 11:01 AM
Remote pin on Krypton CPU
There are three options of Remote pin working modes 1st option: Disabled     - On/off function of Krypton CPU device works only with ON/OFF button on...
Tue, 16 Jun, 2020 at 8:25 PM
One wire reader
One wire reader is an Ethernet to USB adapter, which is used for editing TEDS within the TEDS editor for EtherCAT devices, as EtherCAT devices are currently...
Mon, 20 Jul, 2020 at 11:02 AM
DO digital out operation
The digital output option is available on many Dewesoft devices like KRYPTONi-4xDO, KRYPTONi-16xDO, KRYPTONi-8xDI-8xDO, IOLITE-32xDO and on different SIRIUS...
Tue, 31 Mar, 2020 at 2:54 PM
Sensors : IEPE, ICP, CCLD, IsoTron, DetlaTron
Integrated Electronics Piezo-Electric IEPE is a set of initials for “Integrated Electronic Piezo Electric”. It is a standard for electronics in transduc...
Wed, 13 May, 2020 at 9:28 AM
Noise floor measurement - several approaches
From FFT preview Select Channel Set Sample rate eg. 50kHz Set FFT options to: DC Cutoff 10Hz Line resolution 8192 lines (df=3.05 Hz should be ...
Thu, 11 Jun, 2020 at 9:56 AM
IEPE mode LED function
When you connect the sensor to the BNC connector in the IEPE mode, the LED light will indicate the following operation stages. The LED lights are the same i...
Thu, 1 Oct, 2020 at 8:13 AM
Interfacing NPN / PNP discrete sensor outputs
Many times users have trouble with interfacing sensor outputs most commonly known as: NPN / PNP logic Open Collector, Open Drain Low side / High side ...
Tue, 3 Nov, 2020 at 11:24 AM